User Manual

3
18
GETTING STARTED
Please register your Fuji Spray Product at www.fujispray.com/product-registration
NOTE: Throughout this Manual we have used the generic word ‘Paint’ to
describe all and any coatings. Please substitute the word ‘Paint’ for
whatever finish or coating you are spraying.
Your Fuji Spray Gun has been adjusted at the factory and is ready for
spraying. To clean out any impurities that may have accumulated during
assembly or shipping, we recommend spraying a small quantity of clean
paint thinner through the gun. Before tackling any serious spraying,
experiment with the Gun on a scrap piece of wood until you become
familiar with all the controls.
HOSE CONNECTION
Connect the Hex Nut at the end of the Hose (Female Connector) to the
Turbine Air Outlet. Tighten this Nut lightly. Overturning could cause
the internal Manifold to rotate and break the internal Seal to the
Motor. A Male Quick Connect Coupler 2046M is available as an acces-
sory for the connection to the turbine.
AIR CONTROL VALVE
The Air Control Valve 2032 is located on the Hose next to the brass
Quick-Connect. It provides you with a means of controlling the air flow
through the Gun. It offers you fingertip control when you need it to
reduce bounceback and overspray. It is important to remember that the
Air Control Valve - is the ‘last in the chain’ of operations after...
1) Thinning the paint
2) Adjusting the shape and size of the spray pattern
3) Adjusting the flow of paint through the Gun.
After performing these operations, you should spray a few passes onto a
scrap piece of plywood or cardboard. This will allow you to determine if
the paint levels nicely. Once the Gun is producing a perfect finish with
full air, you may then experiment with turning the air down until
bounceback is reduced to a mininum. However, if orange-peel results,
you have no option but to turn the air up again a slight amount.
PLASTIC DIAPHRAGM
The 1 Quart pressurized Cup has a plastic Diaphragm 2038 (not found in
the Gravity Spray Gun). This Diaphragm prevents paint from entering the
Pressure Tube 2024. The small air hole in the Diaphragm should not be
placed directly below the air hole in the Nipple. Position the Diaphragm
hole to the rear of the Cup. The Spray Gun can be turned to different
angles when spraying but never turned more than horizontal.
GUN HOLDER INSTALLATION
The 2 holes on the top of the Holder require the 2 Machine
Screws and Washers. These Screws fit into Threaded Inserts in
the Metal Case. Do not over tighten - snug is fine.
The single Silver-Colored Screw must be installed to the single
hole on the side of the Gun Holder. Once again, please do not
over tighten this screw - snug is fine.
If you do not intend on using the Gun Holder you may insert the
appropriate screws (as mentioned above) to block the holes.
GUN HOLDER USE
Place the Hose Connector 5229 (base of the Gun Handle) over
the shaft of the Gun Holder shown in above illustration. Please
ensure it is fully set down to the base of the shaft. The Spray
Gun will now sit stationary. The Gun can be left on the Holder for
any length of time. It is a convenient resting place between
spraying and ideal for filling the Gravity Cup.
GUN HOLDER & FILLING STATION