Full Product Manual

· Always store the unit inside in a dry location. Store on the fl oor if in
a basement a basement setting.
· The operator must wear shoes and the fl oor must not be wet.
FIRE AND EXPLOSION HAZARD
Turbine must not be used in an area contaminated by volatile or
fl ammable materials since sparking can be expected in the nor-
mal operation of the motor. This could ignite the contaminants
causing a dangerous explosion.
· Do not spray fl ammable or combustible materials near an open
fl ame or sources of ignition such as cigarettes, motors, and
electrical equipment.
· Keep spray area well-ventilated. Keep a good supply of fresh air
moving through the area. Keep turbine in a well ventilated area.
· Do not spray turbine.
· Turn off and disconnect power cord before servicing equipment.
· Do not smoke in the spray area.
· Do not operate light switches, engines, or similar spark producing
products in the spray area.
· Keep area clean and free of paint or solvent containers, rags, and
other fl ammable materials.
· Fire extinguisher equipment shall be present and working.
· Sprayer generates sparks. When fl ammable liquid is used in or
near the sprayer or for fl ushing or cleaning, keep sprayer at least
20 feet (6 m) away from explosive vapors or spraying area.
· Ensure ground prongs are intact on sprayer and extension cords.
· Always disconnect unit from main supply when fi lling the paint
container.
· Never use 1,1,1-trichloroethane, methylene chloride, other
halogenated hydrocarbon solvents or fl uids containing such
solvents in equipment with aluminum wetted parts. Such use
could result in a serious chemical reaction, with the possibility
of explosion. Consult your fl uid suppliers to ensure that
the fl uids being used are compatible with aluminum parts.
TOXIC FLUID OR FUMES HAZARD
Toxic fl uids or fumes can cause serious injury or death if
splashed in the eyes or on skin, inhaled, or swallowed.
· Read MSDS (Material Safety Data Sheet) to know the specifi c
hazards of the fl uids you are using.
3
22
GUN HOLDER INSTALLATION
The 2 holes on the top of the Holder require the Black Machine
Screws and Washers. These Screws fit into Threaded Inserts in
the Metal Case. Do not overtighten - snug is fine.
The single Silver-Colored Screw must be installed to the single
hole on the side of the Gun Holder. Once again, please do not
overtighten this screw - snug is fine.
GUN HOLDER USE
Place the Hose Connector 11 (base of the Gun Handle) over the
shaft of the Gun Holder shown in above illustration. Please
ensure it is fully set down to the base of the Shaft. The Spray
Gun will now sit stationary. The Gun can be left on the Holder for
any length of time. It is a convenient resting place between
spraying.
GUN HOLDER