Instructions / Assembly

29$
Maintenance
WARNING: IMPORTANT!
Before lighting, inspect the gas supply piping or hose prior to
turning the gas “on”. If there is evidence of cuts, wear or
abrasion, it must be replaced prior to use.
Grill Burner:
Remove grill lid, diffuser panel, grate, and burner. Remove the
screws holding burner to grill body by unscrewing counter-
clockwise.
Grill Burner Flame Height:
The factory burners have been set for the correct air and gas
mixture. The correct flame pattern is shown in (FIG. 3).
1: Burner tube
2: Tips occasionally flicker yellow
3: Light blue
4: Dark blue
If flames do not appear to be uniform throughout the burner
tube, check if the ventilation openings of the burner tube are
blocked by dirt, debris, spider webs, etc. In order for burner to
work properly there must be no obstructing the flow of
combustion or ventilation air. Proceed with cleaning instructions
below.
Grill Burner Exterior Cleaning:
Clean the exterior of the burner
with a wire brush. Clean
stubborn scale with a metal
scraper. Clear any clogged
ports with a straightened paper
clip. Never use a wooden toothpick
as it may break off and clog the port.
Shake out any debris. Use a
flashlight to inspect the burner
inlet to ensure it is not blocked
(FIG. 4A). If obstructions can
be seen, use a metal wire coat
hanger that has been straightened
out(FIG 4B). Check and clean burner
/venture tubes for insects and insect
nests. A clogged tube can lead to a
fire beneath the grill.
FIG.$3$
FIG.$4$
$