Instructions / Assembly

26$
LP Gas Hook-Up For Type 1 Or Qcc1 Regulator
(Standard with grill):
The Element by Fuego grill is orificed for use with LP gas and
comes equipped with a high capacity hose and regulator
assembly for connection to a standard 20lb. LP cylinder (Type
1). The LP tank is not included. LP hose and fittings are
included. Operatingpressure: 11” W.C.
To connect the LP regulator and
hose assembly to the tank/valve
assembly, first make sure the
main valve on the tank is completely
closed. Although the flow of gas is
stopped when the Type 1 system is
disconnected as part of its safety
feature, you should always turn off
the LP tank main valve (FIG. 01)
after each use and during transport
of the tank or unit. Insert the
regulator inlet into the tank valve
and turn the black coupler clockwise
until the coupler tightens up. Do not
over tighten the coupler. Turn the
main tank valve on and turn the
burner control valve on the unit to the high
on position for about 20 seconds to
allow the air in the system to purge,
turn valves off and wait 5 minutes
before attempting to light the
burners.
FIG. 1
To disconnect the coupler, first make sure the main tank valve
is turned off. Grasp the coupler and turn counter-clockwise.
The inlet will then disengage, remove the inlet from the tank
valve opening if it has not already done so when disengaged.
Your local LP filling station should be equipped with the
proper equipment to fill your tank.
LP Tank Requirements:
A dented or rusted LP tank may be hazardous and should be
checked by your local supplier. Never use a cylinder with a
damaged valve. The cylinder used must include a collar to
protect the cylinder valve. Always check for leaks after every
LP tank change. The LP gas cylinder must be constructed and
manufactured in accordance with specifications for LP gas
cylinders of the U.S. Department of Transportation (DOT or
CAN/CSA-B339) and designed for use with a Type 1 system