Instructions / Assembly

24$
5. If ignition does not occur in 5
seconds, turn the burner control off,
wait 5 minutes for any excess gas to
dissipate. Repeat step 1 through 5.
6. After burners are lit, turn knob to the
 zone to operate the dual zone
burners (FIG B) at 21k BTU) or  zone
to operate outer ring (FIG C) at 15k BTU
for indirect heat.
MATCH LIGHTING:
1. Repeat step 1 through 3 in the
previous lighting instructions; put a
match into the lighting rod, light the
match and place it through the hole of
flame tamer to the burner; push control
knob and turn slowly to the
START/ALLUMER ( ) position.
2. If ignition does not occur in 5
seconds, turn the burner control off,
wait 5 minutes for any excess gas to
dissipate.
3. After burners are lit, turn knob to the
 zone to operate the dual zone
burners inner and outer ring  at 21k
BTU) or  zone to operate outer ring
 at 15k BTU for indirect heat.