Owner's Manual

Lighting Instruction Manual
Warning: Before Lighting, please make sure that the control knob
is in the off position and the regulator assembly is in good
condition.
Control Knob. IMPORTANT Do not leave items on or against the
barbecue. Keep flammable product and sprays away.
For outdoor use only.
SHUT DOWN INSTRUCTIONS:
1.Turn burner control knob to the OFF position.
2.Turn gas supply OFF.
3.The gas supply must be turned off when appliance is not in use.
LIGHTING INSTRUCTIONS
1. Read instructions before lighting.
2. Open lid during lighting and make sure burner is in the OFF
position. Make sure the burner kit is properly fixed with respect
to the orifices. Control knob must be in the “OFF” position.
3. Turn on tank valve or gas supply and do the leak testing as the
procedures shown in the manual.
4. Push and turn the control knob to “HIGH”. Push the igniter
button. The burner should light. If it does not, repeat up to
three times.
5. If ignition does not occur within 5 seconds, turn the burner
control knob “OFF”, wait 5 minutes for any excess gas to
dissipate. Repeat step 1 through 5.
6. After burners are lit, turn knob to the ◉ zone to operate the
dual zone burners (FIGB) at 21k BTU/hr or ○ zone to operate
outer ring at 15k BTU/hr for indirect heat.
MATCH LIGHTING:
1. Repeat step 1 through 3 in the previous lighting instructions;
put a match into the lighting rod, light the match and place it
through the hole of flame tamer to the burner tube; Push
control knob and turn slowly to the START/ALLUMER position.
2. If ignition does not occur within 5 seconds, turn the burner
control off, wait 5 minutes for any excess gas to dissipate.
3. After burners are lit, turn knob to the ◉zone to operate the
dual zone burners inner and outer ring ◉ at 21k BTU/hr
or○zone to operate outer ring ○ at 15k BTU/hr for indirect heat.
Important: Always use the lighting rod (include) when lighting
burners with a match.