Specifications

TUBES
INSTALLATION INSTRUCTIONS
Magic Glass Ceiling Tube
.
Email: [e-mail] | www.fudakinlighting.com
340 Marshall Avenue #103, Aurora IL 60506 | Telephone [phone] | Fax [phone]
3. fluorescent2. fluorescent 4. LED T8 tube 6.
on1. off 5. LED T8 tube
!
WARNING!
Installation Diagram
●Risk of electric shock. Switch off the power before replacement.
●Suitable for dry locations. Do not use where directly expose to water.
●Do not use with dimmers. This device is not intended for use with emergency exits.
●This lamp only operates on electronic ballasts.
●Or be used as Type B lamps, and may be operated directly from the branch circuit(mains)
without the need for a fluorescent ballast.
●Caution - risk of fire. Use only in place of fluorescent lamps specified on label or in
accordance with its electrical ratings. Do not install this lamp in a pre-heat luminaire.
●Caution - if the lamp or luminaire exhibits undesirable operation (buzzing, flickering, etc.),
immediately turn off power, remove lamp from luminaire and contact manufacturer or
qualified electrician.
L
N
WHT
T8 LED Tube
BLK
T8 LED Tube
L N
AC120-277V
1.Swich of the power before replacement.
2.Remove diffuser (if needed).
3.Remove the existing fluorescent lamp.
4.Verify the existing ballast is on our ballast list or not.
· If led tube can be compatible with existing ballast:
Plug T8 LED tube into lamp holders of existing fixture.
Put on diffuser (if removed in step 2)
Turn on power and check the light distribution.
· If LED tube can’t work with existing ballast or the ballast doesn't work:
A qualified electrician is needed and,
Remove the existing ballast and rewire as AC 100-277V input
Put on LED tube into the lamp holders of existing fixture.
Put on the cover diffuser (if needed)
Turn on the power and check the light distribution.