assembly Instructions

QUICK-FIX
Installation instructions
PREPARATION
Before assembly, please check that the oor is at a
90 degree angle to the wall. If there is any deviation,
use a waterproof oor-levelling compound, taking
into account the manufacturer’s instructions regar-
ding drying times and application. You can then
place a loose glass brick onto a long board (without
adhesive).
Lay a short board down between the individual
glass blocks (again, without adhesive) to measure
the length of the nished wall. Shorten the board if
necessary, or lay a second board down if needed.
The long boards (95,5 cm) are suitable for exactly
ve 19x19 cm glass blocks or four 24x24 cm glass
blocks.
PLEASE NOTE
Please note that the bricks are made of glass, and
therefore should be handled with care. Avoid pla-
cing glass on glass, or using a hammer or other similar
tools on the bricks. Work slowly and carefully to ensu-
re you’ll be happy with the results!
If possible, glue the oor and wall boards down a
day before the glass bricks so you have a stable
base to work on. To make sure our special SRT 8
adhesive completely dries out, it should be ‘lightly
sprinkled’ with water. Hide any barcodes on clear
glass bricks by laying the bricks up to eye-height with
the barcode facing up (7 or 8 rows), and laying the
bricks above eye-height with the barcode facing
down. When installing corner elements and corner
bricks, you’ll have to cut the board with a mitred
corner. The same goes for installing half bricks.
The maximum allowable dimensions of a single-side
wall installed with QUICK-FIX is 200x200 cm or 180x220
cm (successful pendulum impact test in accordan-
ce with DIN 4103-1, certied by the Material Testing
Facility in Braunschweig).
If you are planning a larger project, please contact
us before installation on:
Tel: [phone] or [e-mail]
English