User manual FTX5593Y-COPY-1

RUNNING YOUR CAR

5. TUNING THE STEERING TRIM

STEERING TRIM BUTTONS

Gently pull the trigger to allow your car to run slowly.

Meantime, tune the steering trim to allow the front

wheels to be aligned by pressing the left or right

buttons.

STEERING

6. TUNING THE THROTTLE TRIM

7. TO TUNE THE STEERING DUAL RATE CONTROL DIAL

THROTTLE TRIM BUTTONS

Throttle Trim is used to set the idle speed of the car,

by pressing the left or right buttons.

LED INDICATOR:

• When using the trim keys the G.LED will ash slowly

for short presses and quickly on long presses.

• When the adjustment value is at the midpoint,

the G.LED will ash twice slowly.

• When the adjustment value is at the end of either + or - ,

the trim adjustment is at its maximum and as such G.LED will not ash.

THROTTLE TRIM

STEERING D/R

8. STEERING/THROTTLE REVERSE

This function is used to adjust each channels direction of movement in relation to

it’s input .

The ST.REV/TH.REV switches are the reverse buttons for CH1 and CH2. If the

switch is up it indicates reverse, down indicates normal..

LED INDICATOR:

• When using the trim keys the G.LED will ash slowly on short presses and

quickly on long presses.

• When the adjustment reaches the end point the G.LED will no longer ash.

STEERING D/R KNOB:

The buttons marked “ST/DR” is for servo travel

adjustment. You should adjust this to give maximum

steering without straining the servo.

Adjustment range: 0-120%(the default is 100%),

the step is 5%.

ST.D / R + : increase servo travel.

ST.D / R – : decrease servo travel.

FTXOB3PassoManual.indd 9FTXOB3PassoManual.indd 9 19/07/2021 12:1019/07/2021 12:10