User Manual Torro 1:10e Nitro Trophy Truck 4Wd RTR - Blue

4
QUICK START GUIDE
Step 1
Install 4 “AA” batteries into the transmitter as per the Etronix
instruction booklet noting the proper direction of each cell.
Step 2
Open the radio box and Install 4 “AA” batteries in the battery holder
noting the proper direction of each cell.
Step 3
Insert the antenna tube in the top of the radio box. Feed the receiver
antenna through the tube until several inches extend out the top.
Install the antenna tip. If you choose to cut the tube down to size, do
so without the antenna installed.
Step 5
Apply air lter oil to help keep the dirt
out. The best method is to remove
the end cap (keep the lter connected
to the carb) and remove the foam
element. Dab the treatment all around
the lter, put the lter in a plastic
sandwich bag, and knead it until the
lter issaturated, but not soaked.
Step 6
Starting the Engine
You MUST read the engine running in guidelines and set-up on pages
9-12 before trying to start your engine. Below is a quick overview of
the starting procedure once the engine is RUN-IN.
1. Before attempting to start the engine from cold,remove the
glowplug with an 8mm nut driver prime the engine with fuel pull
the pullstarter rapidly with your nger over the exhaust pipe outlet
(IMPORTANT- only when cold!) until the
fuel has travelled to the carb, and then a
further 10-20 times to lube the engine.
Do not extend fully the pull start beyond.
Keep the extension to around 20cm with
short sharp pulls.
Do not extend fully the pull start beyond.
Step 4
Turn on the transmitter and then the receiver. Check to make sure
that the servos are operating correctly and that the carburetor closes
when the throttle trigger is released.
AT THIS POINT PLEASE FOLLOW THE SEPARATE ETRONIX RADIO
INSTRUCTION BOOKLET FOR RADIO SET-UP. MAKE SURE THAT YOU
SET THE FAILSAFE FEATURE ON THE TRANSMITTER.
FTXTorroIDManual.indd 4 12/07/2019 13:26