Skyflash Racing Drone Set User Manual With 720P Goggles and Course Obstacles

5.5.2AUTOMATIC TRIM / RESET.
The X-Drone is equipped with an auto-trim system whereby its default settings can be restored, allowing
the aircraft to y in an accurate and level manner.
When must we use this function?
- If the aircraft has taken an impact and as a result its Gyroscope/Electronic stabilizer is o󰀨-kilter.
- If you have transported the aircraft from one place to another.
- If your X-DRONE does not maintain its xed position when hovering.
Automatic trim: To return the transmitter to its original default setting press and hold down the “automatic
trim” button, located in the upper left section of the transmitter while turning the on/o󰀨 switch to the ON
position. This function can be carried out regardless of whether the Skyash and transmitter have
previously been synched/linked.
As you can see, when both joysticks are moved to
the reset position the lights on the drone will start to
ash rapidly, which means that the reset process is
being carried out, once 10 seconds have elapsed,
return both joysticks their initial position, at that time
the lights on the Skyash will stop ashing, which
means that the reset has completed successfully.
5.7APP CONTROLLER MODE
Now you can control your Skyash from your Smartphone thanks to the new FTX FPV App. This option
is available only for versions equipped with WiFi SD/HD camera.
To activate control APP mode, you must follow the following steps:
1. Connect your Skyash battery and place it on a horizontal surface.
2. Switch on the transmitter.
3. Be sure the camera is turned on.
4. Access the menu of your Smartphone WiFi networks.
5. Select the Wi network that has been generated by your Skyash and make sure it is connected
properly.
6. Once the connection has been made, access you’re the FTX App.
If the connection is made successfully, once you press PLAY, you should receive the live images.
In case of not receiving the signal, disconnect your Skyash, restart your WiFi connection and repeat the
process again.
The Skyash has 4 programmable speeds:
Press the speed selector (1) to switch between the di󰀨erent speeds.
When you hear a “beep” the model will be in the slow mode.
When you hear two “beeps” the model will be in the intermediate speed mode.
When you hear three “beeps” the model will be in the fast speed mode.
When you hear a continuous “beep” the model will be in fast/acrobatic speed mode.
5.6SPEED SELECTOR