Skyflash Racing Drone Set User Manual With 720P Goggles and Course Obstacles
5.1INSERTING THE BATTERIES
To insert the batteries in the transmitter, remove the battery compartment cover and insert 4 “AA” size
1.5v batteries (not included) / paying special attention to their polarity to ensure that the transmitter oper-
ates correctly. You may need to use a screwdriver to open the rear cover.
5.2REMOTE CONTROLLER COMMANDS
To insert the batteries in the transmitter, remove the battery compartment cover and insert 4 “AA” size
1.5v batteries (not included) / paying special attention to their polarity to ensure that the transmitter oper-
ates correctly. You may need to use a screwdriver to open the rear cover.
Recommendations:
Batteries must be tted under the
supervision of an adult.
Do not mix new batteries with used
ones.
Do not mix batteries of dierent
kinds.
1. Speed selector.
2. Smartphone holder.
3. Camera button.
4. Power LED.
5. Left control stick.
6. Manual Trim A.
7. Manual Trim B.
8. Camera LED.
9. Right control stick / Flip & Roll button.
10. Manual Trim C
11. Manual Trim D.
5.3BINDING THE REMOTE CONTROLLER WITH THE DRONE
1. Connect your Skyash’s battery, having rst checked that it is correctly charged. If your model has an
on/o switch, make sure it is in the ON position.
2. Place your Skyash on a at surface.
3. Pull the transmitter left control joystick downwards.
4. Turn on the transmitter.
5. Very slowly, move the left control joystick to its upper limit and then move it down slowly.
If you have followed these steps correctly, at the moment when the left control joystick returns to its
starting position in the lower position, you will see that the LED light stops ashing. This tells you that the
transmitter and your drone are now synched.