User`s manual

User’s manual · TWSF 310 CI
- 13 - TWSF 310 CI version_en_1.0 FTE maximal
Summary table:
2. Auto
This option allows saving and loading the configuration of the module in the PRO
201 programmer.
- Read from module: It stores the current configuration of the module in the memory of the programmer. The steps to
make a correct reading of the headend are specified below:
1. Select the option “Read from
module” through Up/Down buttons.
Press OK to continue
2. Select the position of “CFG”
memory where you wish to save the
current configuration of the module.
3. A window will appear and it will let
you know that the reading made has
been correct
- Write to module: It loads in the module one of the configurations previously saved in the memory of the programmer. The
steps to make a correct configuration of the headend are specified below:
1. Select the option “Write to module”
through Up/Down buttons. Press OK
to continue
2. Select the position of the “CFG”
memory that you wish to copy in the
module. Please verify that the data of
the selected memory correspond to
the channel that you wish to copy.
Through the up/down keys, it
commutates between the 2 units of
the module (Mux 0 / Mux 1)
3. A window will appear and it will let
you know that the configuration made
has been correct
3. Config
In “Config” option the information concerning the transmodulator is given.
Satellite input Terrestrial output TV output
- L.O. frequency
- Input Frequency
- Symbol Rate
- Antenna
- Diseqc
- Symbol rate auto
- DVB Mode
- Modulation
- Invert (Spectrum Inversion)
- Guard Interval (GI)
- Bandwith (BW)
- Tx Mode (FFT Mode)
- FEC
- Mode
- RF Channel
- RF Level
TWSF 310 CI
Operation finish
TWSF 310 CI
Mux: 0 CFG:01
Freq:11362 Sr:27500
Output Freq:850000
TWSF 310 CI
> *Write to Module *
*Read from Module*
TWSF 310 CI
Operation finish
TWSF 310 CI
CFG:03
Free position
TWSF 310 CI
> *Read from Module*
*Write to Module *
TWSF 310 CI
> *Read from Module*
*Write to Module *
TWSF 310 CI
LCN
>Read file
D
elete
f
ile