User`s manual

User’s manual · TWSF 310 CI
- 11 - TWSF 310 CI version_en_1.0 FTE maximal
9. Common Interface
This option allows checking the information and configuring the parameters
regarding the conditional access.
- Selecting Slot: It selects the Slot where the CAM for decoding the
services is inserted.
- CI Menu: From here you can reach the menu of the card inserted in
the CAM.
- Decrypted: From this option you can add or remove manually the
services that are being decoded by the card.
- Deactivating all decrypted: From this option you can remove all the
services that are decoding the conditional access card.
- CAM Reset: It allows making a reset in the CAM.
- Watchdog CAM: In cases where the encoded services stop working
you can use one of the following options.
- Deactivate: No actions will me made in the CAM.
- Update: When it is detected that the decryption of the CAM
has been lost, the rights will be sent systematically until the
decryption gets back.
- Reset: As soon as the loss of decryption of the CAM is
detected, a reset will be made.
- Both: Once the loss of decryption of the CAM is detected,
the rights will be sent several times until the decryption gets
back. In cases where it does not get back the module will
make a reset of the CAM.
- CAM Reset after: It makes a reset of the CAM alter a set period of time.
Options: 0, 5 min , 10 min, 15 min
- CI daily reset: By activating this option we will be able to make a daily
reset of the CAM.
- CI daily reset time: Time when the CAM resets in case the “CI daily
reset” option is activated.
- Activated slots: It allows selecting the CAM modules that should get a
reset, in case the “CI daily reset” option is activated.
PRO 201
Note: From PRO 201 programmer you can only carry out the programming of a single module, in order to carry
out the programming of several modules at the same time you have to use a mediaMAX EVO or mediaMAX
MINI series field strength meter.
When you connect the PRO 201 programmer, it will proceed to recognize the
module and to show the main menu.
In the main menu are shown the different options for configuring the
transmodulator.
We have to use the “Up” and “Down” buttons of the keyboard in order to move to the different options, and to get into the
submenus we have to press “OK” button.
1. Manual
Inside the “manual” menu there are specified the different options for setting up the input, output and modulation
parameters.
Nota: It will allow you to choose between two units with an only device
connected to the programmer (Unit 1(Mux 0) or Unit 2 (Mux 1)).
TWSF310CI
>Manual< Config
Auto
TWSF310CI
>Mux 1<
Mux 0