User`s manual

User’s manual · TSF 310 CI
- 3 - TSF 310 CI version_en_2.0 FTE maximal
Stages of transmodulator TSF 310 CI
Input
Selection of a tuned satellite transponder
Transmodulation
Models with a serial number lower than a 075511441882 Models with a serial number higher than a 075511441882
The tuned channels of the transponder are modulated
according to the DVB-T rules. If the transponder has
encoded channels, in order to distribute them freely you
have to install the PCMCIA + subscriber card in the
Common Interface slot.
The tuned channels of the transponder are modulated
according to the DVB-T rules in two multiplex. In cases
where the transponder has encoded channels, if you wish
to distribute them freely, you will have to link a PCMCIA +
subscriber card to each one of the two outputs of the
multiplex.
Out
Models with a serial number lower than a 075511441882 Models with a serial number higher than a 075511441882
Configuration of the channels and output parameters Configuration of the channel and the output parameters of
the multiplex. The channel of the second multiple will be set
by default as the consecutive channel of the one in the first
multiplex.
1.4. Programming
TSF 310 CI has two ethernet connectors. In order to make the programming of the module you have to connect the
corresponding programmer to PRO 201 connector.
You can make the programming through the PRO 201 programmer and also through the mediaMAX EVO and mediaMAX
MINI field strength meter.
1.4.1. Programming modes
With mediaMAX EVO / mediaMAX MINI field strength
meter you can carry out the programming of all the
modules consecutively as long as they are interconnected
with each other through the RJ-45 cable supplied with
each unit.
Through PRO 201, the programming is made module by
module.