User`s manual

User’s manual · TFF 310 CI
- 8 - TFF 310 CI version_en_1.0 FTE maximal
- Working disk: With this option we have the possibility of choosing if we want to work into the internal disk or in the
external storage device USB 2.0.
Once the option is selected, a dialog box will appear and we will be able to choose among three different options.
- Auto: The Meter decides where the data will be stored. If there is external memory connected, the Meter will
store the data in it. If not, it will use the internal memory.
- USB: The Meter always will try to use the external memory connected to the USB port. If this memory has not
been connected an error message will be shown, reminding that there was an error storing the data and it will be
not stored.
- Internal: Always the internal memory is used to store the data.
- Load programs from USB: This option allows importing programs from a USB memory to the field strength meter. Before
using this option you must connect a USB memory.
- Save programs to USB: This option allows copying the programs stored in the external USB 2.0 storage device.
- Write Alias: It allows saving the alias of the module in the program. Options: Yes/No
8. Set Output Services
This option allows making the selection of the services that you wish to include in
the output multiplex.
- Add/Remove services: It allows adding the services to the multiplex and also
removing the ones previously included. The lower bar informs about the available
space in the output multiplex. As you add more services, the space available will
decrease.
Once you have tuned a multiplex in the “Input Set Up” section and you have
selected the DVB-T/DVB-H modulator configuration in the “Modulator Set Up”
section, you can make the assignment of the services that are going to be
included in the output multiplex “Adding/Removing services”.
Adding services:
1. Select “Service to add” option 2. Select one of the multiplex
services you want to add.
3. Once you have chosen the
service, select the “Add/Remove”
button to include the service in
the multiplex.
Note: It is not recommended to exceed the 85% of the maximum capacity of the multiplex due to the possible
variability of the bits rate of the inputs services.
Recomendad capacity
(lower to 85%)
Excessive capacity
It is recommended to remove
services