User`s manual

40
User’s Manual - mediaMAX MINI
Reserved of technical modifi cations and/or errors
ENGLISH
rev 2.1
10.2.3 Use spectrum mode to spot a signal
To represent the frequency spectrum on the screen and spot a signal, press the “spectrum” key.
To identify the target signal, an easy way could be use 100MHz bandwidth span. For select it, use left
and right arrows keys. The span current value is shown at the left bottom part of the monitor.
With the spectrum on screen, move the rotary wheel to sweep the frequency band to spot the target
signal.
In satellite band, “nav” key selects only frequency mode to sweep the band normally by frequency
with 500 KHz steps.
10.2.4 Measurement selection
With the target signal identifi ed, it’s necessary to select the signal type (analog or digital). Press
“op-
tions”
key, select “Digital modulation” and there will be two differents options:
Analog: if analog signal
Digital: if digital signal
•
•