User`s manual

38
User’s Manual - mediaMAX MINI
Reserved of technical modifi cations and/or errors
ENGLISH
rev 2.1
10.2 Satellite signal measurement
10.2.1 Frequency band selection
For satellite band selection, press once the
“band” key until the monitor shows the message “Switch-
ing to satellite band”. The switching sequence is the following:
Terrestial band -> Cable band -> Satellite band
Once this option has been selected, a satellite dish appears on the left top of the status bar.
10.2.2 Supply LNB power
With satellite band it is important supply power to LNB in order to get the signal from the differents
satellite band and polarities.
Polarity. There are two options:
Vertical: 13 V
Horizontal: 18 V
Bands. There are two options:
High: 22 KHz tone
Low: Without tone
To active the LNB power supply, press through RF-IN connector, press “supply” key to open the
menu.
•
1.
2.
•
1.
2.