Operation Manual

Pag.
When you press [OK] key In the “Load Factory Default” item:
1. There will pop a dialogue for you to enter the password, and the default password is “0000”.
2. After you input the correct password, there will show a warning message to inquiry you “The
operation will load
default and erase all the channels that user added, continue?”.
3. If you select “Yes” option, the all revised parameters of the receiver will reset to default value.
Please carefully to using this function.
4. In step 1 and step 2, press [Exit] key can draw back from this item and without saving.
1. We offer the functions for user to connecting receiver (Master) to the other receiver (Slave)
via serial interface to upgrade software code and program list.
2. Connect master receiver to slave receiver via serial interface. Enter “Software Upgrade” menu
in master receiver and press [Left/Right] keys to switch upgrade mode. Upgrade modes include:
allcode / maincode / videoback / radioback / defaultdb1 / userdb
3. Turn on slave receiver and it needn’t operate any setting.
4. Moving highlight to “Start” on master reeciver and press [OK] key to start upgrade.
5. Press [Exit] key to save the parameters and draw back.
MENU OPERATIONS
Pag.24
6.4 SOFTWARE UPGRADE
6.3 LOAD FACTORY DEFAULT