Operation Manual

Pag.
In order to avoid interferences between remote
controls, you have the possibility to change the code
of it, to do that you have to change the position of a
switch in the remote control.
But first of all you have to change this code in the
receiver. You can do this in the menu “Position RCU”.
( OSD41)
You have to select the same position in the receiver
and in the remote control.
6.TOOLS
When you switch to “Tools” menu, you will see a
screen like below(OSD 43): In “Tools” menu:
1. Press [Left/Right] key to select menu pages among
Channel, Installation, System and Tools.
2. Press [Up/Down] key to select menu items among
each items.
3. Press [OK] key to enter the selected item.
OSD 42
OSD 43
IMG 4
OSD 41
MENU OPERATIONS
Pag.22
5.8. RCU POSITION