Operation Manual

Pag.
When you input to “OSD Setting” menu, you will see
a screen like below (OSD 39):
1. Subtitle Display: You can press [Left/Right] key
to select “On” or “Off”. If the current channel has
subtitle information, it will be showed up while this
function is “On”. If this function is “Off”, there won’t
show up subtitle information even if the current
channel has subtitle information.
2. OSD Timeout: When you switch channels in full
screen, there will show up some information about
current channel on the lower of the screen. And
regarding to the duration of these information show up on the screen, you can press [Left/Right]
key to set the time. The range of the duration is “1 second ~ 10seconds”.
3. OSD Transparency: Besides the setting of “OSD Menu Style”, you also can set the transparency
of OSD. You can press [Left/Right] key to select the values. There are 5 levels of transparency,
10%, 20%, 30%, and 40% and “NO” (means no transparency function).
4. Load OSD Setting Default: If you are not satisfy with your setting, you can move highlight
to this item and press [OK] key to reset parameters as default value.
You can set a password for anyone who wishes to
operate in the “Installation” menu. And you can also
set the password for the lock channels. (How to set
the lock channel please refer to LOCK) Here will
show you how to setting and how to revising the
password.
1.In “Parental Lock” function, press [OK] key, there
will pop an dialogue for you to input the password.
The default password is “0000”. When you input the
correct password, you will see a screen like
below(OSD 40):
2.Menu Lock determining that when user wish to enter “Installation” menu, whether have to
input Password or not. If the setting of “Menu Lock” is “Yes” which means user have to key in
password, set “No” means unlock.
3. Channel Lock determining that when user wish to play the lock channels, whether have to
input the password or not. If the setting is “Yes”, play the channels with lock mark will show up
a dialogue on the screen and ask for the password. If the setting of “Channel Lock ”is “No”, the
Lock function will invalid.
4. New Password is used for revising password; you can input the new password in this item
by using number keys directly. After you filled in 4 digital numbers, the highlight will auto skip
to Confirm Password and ask you to input the new password again. If the password is correct,
the screen will show up a message of “Change password successfully”. After finish saving and
draw back to “System Setup” menu, the revising is complete.
5.Press [Exit] key to draw back from the “Parental Lock” menu.
OSD 39
OSD 40
MENU OPERATIONS
Pag.21
5.6 OSD SETTING
5.7 PARENTAL LOCK