Operation Manual

Pag.
Pag.1
Coaxial cable (Not included)
SCART (Not included)
Coaxial cable (Not included)
SCART(Not included)
Modulator connection
Follow next steps for the correct installation of this receiver.
Step 1: Connections
Connect a coaxial cable from the output socket to the “Antenna Input” connector. Connect a
coaxial cable from the “Loop out” connector at the receiver to your TV input connector as it is
shown in Scheme1.
Model without modulator (MAX T150):
Scheme1
Scheme2
Scheme3
Receiver output signal is modulated into a RF channel and it is sent to the TV through the
coaxial cable. In order to modify the parameters of modulator, please read point 5.2 of the
manual.
If connection through a SCART cable is desired, please follow Scheme3.
Quick Installation Guide.
This receiver has not built in modulator so it has to be connected to the TV through a SCART
cable.
Model with modulator (MAX T160):