Operation Manual

Pag.
When you enter to “Channel Scan” menu, there will
display the screen like below (OSD 25):
1. There is two mode. You can scan channel by
channel or by frequency” .
2. When scan band is UHF, the range of Ch No. is
from 13 to 61. When scan band is VHF, the range
of Ch No. is from 1 to 12.
3. When you complete your modification,move
highlight to “Search” item and press [OK] key, then
it will begin to scan.
4.In the “Channel Scan” item, press [Exit] key to exit the scanning and save the current parameters.
When you enter to “Channel Setup” menu, there will
display the screen like below:
1. You can see the channel information like the picture
displaying (OSD 26).
2. Move the [Up/Down] key can move the highlight
to select the channel.
3. When press [OK] key again, you can see the
window like below (OSD 27):
4. Input PID information,then move highlight to
“Search” item and press [OK] key, then it will begin
to scan.
OSD 25
OSD 26
OSD 27
MENU OPERATIONS
Pag.16
4.2 CHANNEL SCAN
4.3 CHANNEL SETUP