Operation Manual

PAG.

rev 1.0

ENGLISH

SYSTEM SETUP

and every time when you think that your password is known

by unauthorized persons. To change the password, enter the

new password in the “New Password” item and repeat the

same one in the “Conﬁ rm Password” item. If the passwords

are not identically then you will see a warning message. If you

entered the same new password in both ﬁ elds then you will see

the message “Saving Data, Please Wait…”. From now on you

need to use the new password to open locked menus or locked

channels.

NOTE: The default password is 0000

5. Press [Exit] to leave the “Parental Lock” menu.

5.6. LNB POWER

Here you can set the power output to the LNB (OSD 72). If

your receiver is connected to the LNB directly then you need to

set the LNB Power to “On”. If your receiver is connected to a

multi switch (SMATV signal distribution system) then it may be

that you don’t need to provide the power to the LNB. But since

this is depending on the kind of installed distribution system we

recommend you to contact your installer or to refer to the user

manual of this system to get the correct information.

You also just can change this setting and check if you still can

receive the channels. If the LNB Power is off and you still can

see all channels then we recommend this setting.

5.7. RCU POSITION SWITCH

In order to avoid interferences between remote controls, you

have the possibility to change the code of it, to do that you have

to change the position of a switch in the remote control.

But ﬁ rst of all you have to change this code in the receiver. You

can do this in the menu “RCU Position” (OSD 73).

You have to select the same position in the receiver than in the

remote control (OSD 74).

OSD 72

OSD 73

OSD 74