Operation Manual

PAG.
30
rev 1.0
ENGLISH
SYSTEM SETUP
5.2. TV SYSTEM
When you enter the “TV System” menu you will see the screen
like below (OSD 62):
1. Display Mode is used to switch the display mode. You can
select from Auto / PAL / PAL-M / NTSC 3.58. Press [
] to select the desired mode.
2. Aspect Mode is used to switch the screen aspect ratio mode.
You can select from Auto / 4:3 PS / 4:3 LB / 16:9. Press [
] to select the needed mode.
3. Video Output is use for switching the screen aspect ratio
mode. Now we provide below options: RGB / CVBS. You can
press [ ] key to select each mode circularly.
4. In HDMI Mode, you can choose the number of lines and the
scan mode of the video signal you are sending by the HDMI
connector. Through the arrows [ ], select among: 576P /
480P / 576 I / 480 I. (P: Progressive, I: Interleaved)
Note: If you have the HDMI output connected and you select
the progressive mode, the SCART output is automatically disa-
bled.
6. Press [Exit] to close the “TV System” menu.
* With this model, 4:3 / 16:9 switching is not allowed.
* With this model, RGB output is not allowed.
5.3. TIME & TIMER SETTING
When you enter “Time” “Local Time Setting” or “Sleep Timer” a
menu with three items will be opened (OSD 63). Use [ ]
to select between the three options and confi rm with [OK].
5.3.1. TIMER
Select “Timer” item and press [OK] to enter the “Timer list”
menu (OSD 64).
The current time will be displayed in the fi rst column. If the
current time is incorrect, please modify it with the [Number]
buttons at the “Time” menu.
1. Timer Number: You can press [ ] to set the Timer
number. There are totally 8 timers.
2. Timer Mode: Select how often the timer is running: Once,
Daily, Weekly, Monthly and Yearly. Or switch the timer off.
3. Timer Service: Select between Channel (timer setting for
channel change and Wakeup/Sleep) and Message (reminding
message).
4. When you select “Channel” (timer setting for channel change
and Wakeup/Sleep) then you have further options you need to
set (OSD 65):
- Wakeup Channel: press [OK] to enter the channel list and
select the channel you want to see.
OSD 63
OSD 64
OSD 65
OSD 62