Operation Manual

PAG.
36
rev 1.0
6.5.3. UPGRADING THOUGH USB
This option allows updating the software of the receiver with the
received data from a USB 2.0 memory device. To do it, connect
a USB 2.0 memory device to the receiver and accede to this
menu option (OSD 80).
The last software version to be loaded must be placed at the
root path of your USB device.
1. Upgrade mode: Select with [
], the mode of
upgrading.
2. Update fi le: Select with [ ], the name of the fi le to be
loaded.
3. Select “Start” and press [OK]. An alert message appears
indicating not to take out the memory device during the loading
process.
4. Once the fi le has been loaded, it requires the conformity
to end the upgrading process, writing into the receiver the
upgrading. Press [OK] to upgrade the receiver (OSD 81). In
case during the reading of the fi le, it is corrupted or it would be
a not appropriated for this model of receiver, an alert message
would appear “Error reading the USB disk”.
5. After pressing [OK] the receiver will write into the Flash
memory, and it will reboot to end the upgrading process.
For further information about the upgrading of the receivers,
please visit http://www.ftemaximal.com, in the chapter about
upgrading receivers.
6.6. SATCODX AUTO PROGRAMMING
This function is using the tables of the SatcoDX websites to
update your channel and satellite lists.
1. Start the SatcoDX application on your PC.
2. Select “SatcoDX Auto Programming” item from the “Tools”
menu and press [OK]. The screen will show the message “OK
to Proceed” (OSD 82).
3. Press [OK] again and you will see the message “Ready to
Download” (OSD 83).
4. In the PC application set the Baud Rate to 115200 and start
the download procedure.
! Caution: The new download channels will delete the original
channels list. Please be careful before using it.
TOOLS
OSD 83
OSD 82
OSD 81
OSD 80
ENGLISH