Operation Manual

PAG.

rev 1.2

ENGLISH

PANEL & REMOTE CONTROL DESCRIPTION

1. PANEL & REMOTE CONTROL DESCRIPTION

1.1. FRONT PANEL DESCRIPTION

1. POWER: Switches the receiver on, or enters standby mode. To completely switch off the receiver,

you have to use the switch on the back of the receiver.

2. LOCK LED: Indicates a sufﬁ cient signal level at the IF IN input.

3. DISPLAY: 4 Digits to display the program numbers.

4. IR-SENSOR: Reception sensor for the IR remote control signals.

5. BUTTONS: These buttons allow controlling the main functions of the receiver, and

provide the same functionality as the remote control ones.

1 2 3 45

1. IF IN: Satellite input.

2. IF OUT: Satellite output for cascading to other devices.

Note: The operation of another receiver at the same time is only possible with limited channel

selection.

3. S/PDIF: Coaxial output for digital audio (AC3).

4. TO TV: Modulator output for the connection to a TV set.

5. ANT IN: Antenna input for the terrestrial antenna.

6. AC IN: Mains input cable.

7. POWER ON/OFF: Allows to completely switching off the receiver.

8. RS-232: Serial Port allowing software upgrades.

9. TV SCART: Output SCART for the connection to a TV set.

10. VCR SCART: Output SCART for the connection to a VCR set.

1 2 3 6 7

1.2. REAR PANEL DESCRIPTION