Operation Manual

User’s manual · MAX IPT150
Technical changes and mistakes reserve - 8 - MAX IPT150 Version en_1.0 FTE Maximal
1.4. Fast installation guide
Please, follow the instructions for a faster and simpler installation of the receiver.
Step 1: Connections
Connect a coaxial cable from the output socket to the ANTENNA IN connector.
Connect the ETHERNET input of the receiver to the network.
Connecting TV set, LCD or video beamer:
You can connect in different ways your TV set or other display system:
Scart At this output you will have the best image quality.
This is the connector which will be normally used to connect the TV.
For this purpose, you will need a Scart – Scart connector.
Recorder / DVD At the VCR - Scart connector, you can connect a Video or DVD-Recorder.
Also the signal coming from a DVD player is possible to be wached if your TV set has
Scart connections.
You will find further information at chapter TV Settings.
Output LOOP OUT You can connect this output to the antenna input of your TV or VCR to receive the
analogue terrestrial signal.
You can obtain further information in chapter Receiver back panel.
This receiver has a main switch at the back panel of the receiver.
If a message “short-circuit” in shown, you have a short-circuit in your antenna system.
Please check it and restart the receiver.
When you set up the system for the first time, the current date will be stored in Menu > System Settings > Version
as beginning date for the warranty period.
Step 2: Main settings on receiver
When you start the first time the receiver or when you execute a “factory default” process, you will see this
installation guide in English language.
The selection of the menu options will be done with the arrow buttons
, and the button
OK of the remote control.
Please, choose the code for your remote control in the first window.
Fte Maximal gives you the possibility of using a IP, a DVB-T and a DVB-S
receivers at the same time.
For this purpose, your new receiver is selected by factory with code 2.
You have the possibility to change the code of it, to do that you have to change the
position of a switch in the remote control.
You have to select the same position in the receiver than in the remote control
If you have problems with remote control devices, you can change the transmission
code if you go to Menu > System Settings > OSD Settings after finishing the quick
installation guide.
Menu Language:
Here you have to select the language for the Receiver menu and information.
Select the language with the arrow buttons
and press the OK button.