Operation Manual

User’s manual · MAX IPT150
Technical changes and mistakes reserve - 29 - MAX IPT150 Version en_1.0 FTE Maximal
Streaming protocol You can select the communications protocol. Options: UDP or RTP.
Current Channel It allow you to fix the number of transponder that is going to be sent t othe destination receiver.
No: Always will be sent to the receiver at destination the indicated cannel in the field Channel,
and the origin receiver only will be able to see any cannel belonging to the same transponder
which is indicated in the Channel field, or IP channels.
When you see an IP channel, the streaming sending process will stop.
Yes: the receiver will send the channel which is tuned locally. Every time you
change the channel in the receiver, you must tune the same in the destination
receiver.
Channel: Service to be sent. Only available when you select No in the field Current Channel.
You can move through the menu with the buttons
and .
With the Red button you delete the last character.
Press OK to save the changes.
8.7. Network Management
In this menu you can manage the equipment you decide to receive
streaming from, in mode Unicast.
You can move through the list with the buttons
.
Pressing the Red button you can delete a host from the list.
With the Yellow key a new window will appear where you will be able to
add a new host.
At IP Address introduce the IP address of the sender device.
Every device in the network should have a different IP Address and it is
highly recommended that all of them are in the same subnetwork and with
IP addresses into the following range:
10.x.x.x
172.16.0.0 – 172.31.255.255
192.168.x.x
At Port introduce the number of the port where the information will be
received. The port must be an even number in the range between 1024 –
65534.
You can move with buttons
and .
With the Red button you will delete the last character.
Press OK to add the new host.
With the Green button you can edit the information of the selected host.
With the Blue button the receiver will not take into account the selected
receiver when you carry out a search of IP channels.
8.8. Backup
Here you can save and load personal backups.
Load Backup
This function load one backup from internal receiver memory.
Save Backup
This function saves one backup to the internal receiver memory.
This process overwrites whatever backup made before.
Delete Backup
This function deletes one backup in the internal receiver memory.