Operation Manual

User’s manual · MAX IPT150
Technical changes and mistakes reserve - 10 - MAX IPT150 Version en_1.0 FTE Maximal
Network Configuration
The receiver will require the introduction of the needed parameters to be
able to get connected to a network, as well as to be visible to other
equipments so that receive streaming of video and audio.
You should introduce the following parameters:
IP Address Number of 32 bits expressed in 4 numbers
between 0 and 255 which identifies the receiver
inside its network.
Every device in the network should have a
different IP Address and it is highly recommended
that all of them are in the same subnetwork and
with IP addresses into the following range:
10.x.x.x
172.16.0.0 – 172.31.255.255
192.168.x.x
Subnet Mask Number in IP format that, combined with the IP address, identifies where the equipment is.
IP LAN Soft: IP address of the PC where the application for exchanging video streamings between the
PC and the receiver is installed.
If you want, you can download the application IP LAN Soft from the Website:
www.ftemaximal.com
MAC Device address at hardware level. It is unique in each device and it comes from the factory.
You can move through the menus with the buttons
and .
With the Red button you delete the last character.
Press OK to save the changes.
Streaming Configuration
This receiver can send streaming to other equipment connected to the
network.
You can send video streamings in Unicast and Multicast modes.
- Unicast is when the information is sent from a unique sender to a
unique receiver.
- Multicast in when the information is sent through a network to
multiple destinations simultaneously. The equipment that work in
multicast mode send the information into an IP range between
224.0.0.0 and 239.255.255.255.
In this window you can configure the network parameters of the device at destination:
Streaming You should select On so that the receiver sends the streaming.
Address IP Address of the destination device.
You can simultaneously send the streaming to different devices in case that in this
field a multicast IP address is introduced.
Destination port Communications port where the information is sent.
The port must be an even number in the range between 1024 – 65534.
Streaming protocol You can select the communications protocol. Options: UDP or RTP.