Operation Manual

User’s manual · MAX IPS100
Technical changes and mistakes reserve - 29 - MAX IPS100 Version en_1.0 FTE Maximal
9.2. Channel Search: Satellite
Once the antenna configuration is completed, you should proceed to tune
the satellite channels that you have selected. There are different ways to
tune the channels: through LNB, through Satellites and through
Transponders.
When you select the channel searching through LNB, you only can select
one LNB, which corresponds to the programmed tuner.
When you are searching by satellites, you are allowed to select a Wide range
of satellites, so you could programme the searching of all the satellites that
you have configured.
The searching through Transponder is the most selective. It allows selecting
all the frequencies that you’re going to tune and searching channels.
In whatever selection, you always will have available to search Free To Air
channels (uncoded channels), channels with Conditional Access or All the
channels.
Please, choose the searching pressing the Green button. Once you have
finished (the time will depend on the number of transponders it will have to
find) you will get a window like the following one:
Detected TV Detected
Channels Radio Channels
Level and Quality
Searching process
Meter
You can select the channel searching whenever pressing the Exit button.
Once the searching is finished, you must confirm the storing of a new Channel List.
Press the OK button.
The receiver will come back to the Channel Search menu.
You can search again if you want, or exit by pressing the Exit button.