Operation Manual

User’s manual · MAX IPS100
Technical changes and mistakes reserve - 28 - MAX IPS100 Version en_1.0 FTE Maximal
9. Installation
Over this menu you can search for new channels Channel Search,
modify the frequency list MUX Management, or make backups.
9.1. Antenna configuration:
In this menu you should configure the signals that are connected at the
inputs IF IN of your PVR.
By default, the equipment comes with the configuration that you can see in
the Picture with four satellites.
The available options in this screen allow:
Red button: Deletes the selected satellite. It requests for confirmation.
Green button: Edits the selected satellite. The option appears in the
following image.
Yellow button: Adds a satellite. The options appear in the below image.
Antenna Options:
1. LNB Type: There are two available
bands: C and Ku. The difference is
basically the transmission frequency.
The Ku band has two possibilities, the
most common is the universal Ku.
2. Satellite: Your PVR is provided with
several satellites pre-stored. You can
find the one you want in the list or to
add a new one. They are sorted by its
orbital position. With the key
you
can access to the available satellite
list.
3. Low Band / High Band: It is used
when the band selection is Ku one,
and it programmes the Local
Oscillators of the LNC.
4. DiSEqC 1.0 / 1.1 Ports: To configure the use of antenna switch. These switches allow the
reception of different satellites in a single input.
5. Motor: Enables the function of using a motor to direct the antenna.
6. 22 KHz: Tone to switch the band of the LNC.
7. LNB Power: Feeding to the LNB. By default the selection is the one for an universal LNB.
8. Signal: It shows if there is an available signal in the selected configuration.
Alter whatever change, it should be confirmed with the OK key when you exit the menu.