Operation Manual

User’s manual · MAX IPS100
Technical changes and mistakes reserve - 26 - MAX IPS100 Version en_1.0 FTE Maximal
You have to select the same position in the receiver than in the remote
control.
Info bar delay
Here you can select how long the information of the OSD will be displayed on
the screen.
Selection: 1 to 10 sec.
Please change it with the buttons
.
Number of Sequential Channel
Selecting Yes in this option, the positions of the channels will be occupied
continuously and sequentially. Although you move the position of one
channel, you will shift the positions to avoid leaving empty channels.
Selecting No, you can leave empty channels if we shift the position of one channel.
7.6. Geographical location
For the adjustment of positioners with the USALS system, it is necessary to
have the information about Latitude and Length of your location.
7.7. Version
Here you get information about the hard and software from your receiver.
Manufacturer Manufacturer of the receiver.
Model Exact article name.
Hardware Revisions number from main PCB
Loader Version for boot loader
Software Version for installed software
FP Not available in this model
Guarantee Beginning of the warranty time
CRC Checksum of the EEprom
7.8. Factory Default
With this option you can restore the receiver totally to the status when
the receiver was used the first time.
Caution: Make this only if you are 100% sure, this step can is
irreversible.
7.9. Software Upgrade
With this menu you can transfer data and install new software.
With the buttons
you can choose between the following
possibilities.
Serial port (Download) Start data download via RS-232 connection.
Air (now) Starts data download via OTA immediately
Air (programmed) Starts data download via OTA at a programmed time