Operation Manual

User’s manual · MAX IP90
Technical changes and mistakes reserve - 23 - MAX IP90 Version en_1.0 FTE Maximal
8. Installation
Over this menu you can search for new channels Channel Search,
modify the frequency list MUX Management, or make backups.
8.1. Channel Search
The receiver will carry out a search for channels broadcasted by other
equipment connected to the network.
You can receive transmissions of other equipment in mode Unicast and
Multicast.
- Unicast is when the information is sent from a unique sender to a
unique receiver.
- Multicast in when the information is sent through a network to
multiple destinations simultaneously. The equipment that work in
multicast mode send the information into an IP range between
224.0.0.0 and 239.255.255.255.
In Search Type select Auto to search for all the channels which are
broadcasted by other equipment in your network in multicast mode. If you
select the Host option, it will look for transmissions of the equipment present
in the list Network Management that you select.
In the field Multiplex you should select the hosts from the list Network
Management in which you with to search for channels.
Pressing the Blue button or
a new window will appear, where you can
select the hosts.
You can move the cursor with
.
With the Green button you select the hosts.
Press Exit to go back to the search menu.
If you press the Green button, it will carry out a search of the video IP
channels.
Press Exit to exit.
8.2. Network Configuration
The receiver will require the introduction of the needed parameters to be able
to get connected to a network, as well as to be visible to other equipments so
that receive streaming of video and audio.
You should introduce the following parameters:
IP Address Number of 32 bits expressed in 4 numbers between
0 and 255 which identifies the receiver inside its
network.
Every device in the network should have a different
IP Address and it is highly recommended that all of
them are in the same subnetwork and with IP
addresses into the following range:
10.x.x.x
172.16.0.0 – 172.31.255.255
192.168.x.x