Operation Manual

User’s manual · I-PVR T152 CI HDMI
Technical changes and mistakes reserve - 9 - I-PVR T152 CI HDMI Version en_1.0 FTE Maximal
1.4. Fast installation guide
Please, follow the instructions for a faster and simpler installation of the receiver.
Step 1: Connections
Connect the ETHERNET input of the receiver to the network.
Connecting the antenna cable
Connect the antenna cable coming from your DVB antenna or distribution system to
Antenna IN 1.
Connect the output LOOP OUT 1 to the input Antenna IN 2.
Use the included metal connection bridge.
With the short black cable, you have to connect LOOP OUT 2 to the input ANT IN from
modulator.
Connecting TV set, LCD or video beamer:
You can connect in different ways your TV set or other display system:
Scart This is the connector which will be normally used to connect the TV.
For this purpose, you will need a Scart – Scart connector.
HDMI Connector Connect this output to the TV to get the Video & Audi signals.
Modulator The modulator output gives the lowest picture quality. You only will need this output if
your TV set only have IEC input. You can use the IEC connection cable that is included.
On the receiver, you have to use the connector TO TV.
Please note that with the modulator, you only will have available mono audio signal.
Recorder / DVD At the VCR - Scart connector, you can connect a Video or DVD-Recorder.
Also the signal coming from a DVD player is possible to be watched if your TV set has
Scart connections.
You will find further information at chapter TV Settings.
You can obtain further information in chapter Receiver back panel.
This receiver has a main switch at the back panel of the receiver.
If a message “short-circuit” in shown, you have a short-circuit in your antenna system.
Please check it and restart the receiver.
When you set up the system for the first time, the current date will be stored in Menu > System Settings > Version
as beginning date for the warranty period.
Step 2: Main settings on receiver
When you start the first time the receiver or when you execute a “factory default” process, you will see this
installation guide in English language.
The selection of the menu options will be done with the arrow buttons
, and the button
OK of the remote control.
Please, choose the code for your remote control in the first window.
Fte Maximal gives you the possibility of using a IP, a DVB-T and a DVB-S
receivers at the same time.
For this purpose, your new receiver is selected by factory with code 2.
Please press now the button Code on your remote control until the LED at the
middle is lighting.
You have to select the same position in the receiver than in the remote control.
If you have problems with remote control devices, you can change the
transmission code if you go to Menu > System Settings > OSD Settings after
finishing the quick installation guide.