Operation Manual

User’s manual · I-PVR T152 CI HDMI
Technical changes and mistakes reserve - 11 - I-PVR T152 CI HDMI Version en_1.0 FTE Maximal
You may stop searching by pressing the button Exit .
Once the search is finished, you must confirm if the new found channels have to be stored.
Press for confirm the OK-button.
Now you come back to menu Channel Search.
You can start a new search again, or you can close the menu now with the button Exit .
Network Configuration
The receiver will require the introduction of the needed parameters to be able
to get connected to a network, as well as to be visible to other equipments so
that receive streaming of video and audio.
You should introduce the following parameters:
IP Address Number of 32 bits expressed in 4 numbers between 0
and 255 which identifies the receiver inside its network.
Every device in the network should have a different IP
Address and it is highly recommended that all of them
are in the same subnetwork and with IP addresses into
the following range:
10.x.x.x
172.16.0.0 – 172.31.255.255
192.168.x.x
Subnet Mask Number in IP format that, combined with the IP address, identifies where the equipment is.
IP LAN Soft: IP address of the PC where the application for exchanging video streamings between the
PC and the receiver is installed.
If you want, you can download the application IP LAN Soft from the Website:
www.ftemaximal.com
MAC Device address at hardware level. It is unique in each device and it comes from the factory.
You can move through the menus with the buttons
and .
With the Red button you delete the last character.
Press OK to save the changes.
Streaming Configuration
This receiver can send streaming to other equipment connected to the network.
You can send video streamings in Unicast and Multicast modes.
- Unicast is when the information is sent from a unique sender to a
unique receiver.
- Multicast in when the information is sent through a network to multiple
destinations simultaneously. The equipment that work in multicast
mode send the information into an IP range between 224.0.0.0 and
239.255.255.255.
In this window you can configure the network parameters of the device at
destination:
Streaming You should select On so that the receiver sends the streaming.
Address IP Address of the destination device.
You can simultaneously send the streaming to different devices in case that in this
field a multicast IP address is introduced.
Destination port Communications port where the information is sent.
The port must be a pair number into the range between 1024 – 65534.