User`s manual

User’s manual · ETWF 310
- 3 - ETWF 310 version_en_1.1 FTE maximal
1.4. Programming
ETWF 310 has two ethernet connectors. In order to make the programming of the module you have to connect the
corresponding programmer to PRO 201 connector.
You can make the programming through the PRO 201 programmer and also through the mediaMAX EVO and mediaMAX
MINI field strength meter.
1.4.1. Programming modes
With mediaMAX EVO / mediaMAX MINI field strength
meter you can carry out the programming of all the
modules consecutively as long as they are interconnected
with each other through the RJ-45 cable supplied with
each unit.
Through PRO 201, the programming is made module by
module.
1.4.2. Programming
Below you will find the steps to follow in order to make the programming both from corresponding EVO and MINI field
strength meter as well as from PRO 201.
mediaMAX EVO / mediaMAX MINI
In order to start programming the ETWF 310 encoder, you will have to go to “Tools” option through the key 8 of your field
strength meter and to select the “Transmodulator Prog.“ option.
Then, it will proceed to recognize the module and to show the main menu. In the “Transmodulator Prog.” are shown the
different configuration options that this tool offers: