User`s manual

User’s manual · ETWF 310
- 12 - ETWF 310 version_en_1.1 FTE maximal
- Write to module: It loads in the module one of the configurations previously saved in the memory of the programmer. The
steps to make a correct configuration of the headend are specified below:
1. Select the option “Write to module”
through Up/Down buttons. Press OK
to continue
2. Select the position of the “CFG”
memory that you wish to copy in the
module. Please verify that the data of
the selected memory correspond to
the channel that you wish to copy.
3. A window will appear and it will let
you know that the configuration made
has been correct
3. Config
In “Config” option the information concerning the module is given.
- Read log: It allows reading the registered events in the module.
1. Select the option “Read LOG file”
through Up/Down buttons. Press OK
to continue
2. Press OK again to show the log file. 3. A new window will appear. It will
show the information about the
registered events in the module. Press
the following keys in order to scroll up
and down the screen: “up/down”.
- Delete LOG file: It allows deleting all events stored until this moment.
- Factory default: This option restores the values by default of the modules.
- Update FW: It allows carrying out the firmware update from the programmer.
- Output services: This option allows making the selection of the services that you wish to include in the output multiplex.
Once you have tuned a transponder and you have selected the DVB-T/DVB-H modulator configuration, you can make the
assignment of the services that are going to be included in the output multiplex “Adding/Removing services”.
- Add Services
1. Select the option “Add services”
through Up/Down buttons. Press OK
to continue.
2. Select one of the transponder
services you want to add, through
Left/Right keys and select the “+Add”
button to include the service in the
multiplex
3. A window will appear and it will let
you know that the operation made has
been correct.
ETWF310
Operation finish
ETWF310
Input 000%
PID:00256 TR391 CH1
+Add
ETWF310
BW usage 000%
Delete services
>Add services
ETWF310
N:00000 Status:00
17/10/11 09:21:29
System Ok
ETWF310
OK to Show LOG
ETWF310
Global update:
>Read LOG file
Delete LOG file
ETWF310
Operation finish
ETWF310 CFG:00
Enc.Bitrate:6750
Vid.Resol:720x480
O
utput Freq:682000
ETWF310
> *Write to Module *
*Read from Module*
ETWF310
Global update:
>Read LOG file
Delete LOG file