User`s manual

User’s manual · DVB 310 T / DVB 310 T CI

- 2 - DVB 310 T / DVB 310 T CI version_en_1.2 FTE maximal

1.3.

Description and connections

DVB 310 T module is used for the reception of free channels and DVB 310 T CI module is used for free channels as well

as for codified channels. In both cases, the received channels must follow the DVB-T rule.

Each module allows the reception in COFDM, and the following modulation in PAL/SECAM of a TV or Radio channel.

Main feature of this equipment is its modulator in Vestigial Side Band (or VSB). This modulation can be used to distribute

adjacent channels in one distribution without any intermodulation problem.

Each module has one Loop connector to cascade several modules at input and a Mix connector to do same in output

channels

.The output channel is selectable between C2 and C69.

All the parameters are programmed through PRO 201 programmer, and they are monitored in the display of the

programmer or in the A/V output in the device.

DVB 310 T CI has a Common Interface slot.

DVB 310 T / DVB 310 T CI

1 CI: Common Interface .*

2 Conector A/V: Through this connector and the A/V cable provided with SPS 310, it is possible to visualize the

A/V signal provided by the module.

3 OUT: This connector supplies the modulated channel according to the selected standard in the module and mixes

it with all the signals that it receives throught the MIX connector

4 MIX: Input of mixing of the module.

5 ANT IN: To connect to the antenna or to the LOOP OUT output of the previous module

6 LOOP OUT: To connect to the ANT IN input of the next module.

7 RS 232: Ethernet connector to cascade modules with the RCM 310 telecontrol unit with the RJ45/RJ45 cable

provided.

8 PRO 201: Ethernet connector to make the programming with the programmer.

9 DC connectors: It has two connectors for input/output.

*Note: Only for DVB 310 T CI model