Datasheet

User’s guide · RCM 310
- 17 - RCM 310 version_en_1.0 FTE maximal
Immediate deactivation of the alarm once activated
An alarm gets deactivated once the causes that activated it disappear. Nevertheless, there are some cases where it is
interesting that the alarm gets deactivated immediately, although the events that activated it are still going on (for example
in cases of activation by SMS or when rebooting the system).
Note: When the immediate deactivation of the alarm is chosen, the configured deactivation actions will run (in
case there is any configured).
Alarm Sensitivity
It is possible to configure the alarm sensitivity, so the alarm does not get activated/deactivated immediately when
the events take place.
The sensitivity is configured in number of cycles. The number of cycles implies that, in order to get the alarm
active, the events must take place continually during a set number of cycles
Activation when the system reboots
The system rebooting can be set as cause of alarm. You can select if the rebooting has been forced by the user
(the rebooting button has been pressed) or if the rebooting has been unexpected (the feeding has gone or there has been
any system failure that has caused the rebooting).
Actions that are carried out when the alarm gets activated
This section defines the actions that will be made when the alarm gets activated.
• Modifying leds status: You can make that each one of the Leds turns on, off or remains flicking.
• Modifying relay status: You can open, close or reverse the status of each one of the 4 relays.
• Sending an e-mail: You can send a pre-configured e-mail (defined in the “mail” tab).
• Sending a SMS: You can send a pre-configured SMS (defined in the “GSM” tab).