Datasheet

4
3.1. AC INPUT
Parameter Min. Nom.
(1)
Max. Unit
V
in
(115VAC)
90 115 132
VA C
rms
V
in
(230VAC)
180 230 264
VA C
rms
V
in
Frequency
47 -- 63
HZ
◆ Nominal voltages for test purposes are considered to be within ±1.0V of nominal.
3.2. INRUSH CURRENT
Maximum inrush current from power-on (with power on at any point on the AC sine) and including,
but not limited to, three line cycles, shall be limited to a level below the surge rating of the input
line cord, AC switch if present, bridge rectifier, fuse, and EMI filter components. Repetitive
ON/OFF cycling of the AC input voltage should not damage the power supply or cause the input
fuse to blow.
3.3. INPUT LINE CURRENT & POWER FACTOR (P.F.)
(At Full load)
AC input Input line current P.F.@ Full Load P.F.@ Pin=75W
115V < 3.5 Amps – rms > 0.95 > 0.8
230V < 2.0 Amps – rms > 0.9 > 0.75
3.4. EFFICIENCY
3.4.1 General
Under the load conditions defined in Table 1 and Table 2. The loading condition for testing
efficiency shown in Table 1 represents a fully loaded system. ~ 50% (typical) loaded system. and ~
20% (light) loaded system.
Table 1. Loading Table for Efficiency Measurements
文件資料管制 文件資料管制 文件資料管制 All rights reserved
4/9禁止翻印外洩 All rights reserved ESD16025495-R1.pdf 建立時間:2016/5/18 3:38 下午