Datasheet

ManualsBrandsFSP FORTRON ManualsPower Supply UnitsIndustrial PC PSU FPS300-60GHT 300 W 80 PLUS Bronze

SPECIFICATION

ESD16025495

Released Date:2016/05/18-15:38:12

FSP300-60GHT,(85)F

Summary of content (10 pages)

PAGE 1
SPECIFICATION ESD16025495 FSP300-60GHT,(85)F Released Date:2016/05/18-15:38:12
PAGE 2
文件資料管制文件資料管制文件資料管制 All rights reserved 全漢企業股份有限公司台灣桃園市建國東路 22 號 NO.22,Jianguo E, Rd.,Taoyuan City,Taiwan,R.O.C. TEL:+886-3-375-9888 FAX:+886-3-375-6966 FSP TECHNOLOGY INC. SPECIFICATION FSP300-60GHT,(85)F 9PA300CZ21 Main Feaure: Meet 2013 ErP Meet 80 Plus Bronze Active PFC Circuit Full Range Input MAY. 18, 2016 REV: 1.00 全漢企業股份有限公司 FSP TECHNOLOGY INC. 1/9禁止翻印外洩 All rights reserved ESD16025495-R1.
PAGE 3
文件資料管制文件資料管制文件資料管制 All rights reserved MODEL: FSP300-60GHT,(85)F Revision History Rev Description Date 1.00 Initial Author 2016/05/18 1. GENERAL DESCRIPTION AND SCOPE 2/9禁止翻印外洩 All rights reserved 2 ESD16025495-R1.
PAGE 4
文件資料管制文件資料管制文件資料管制 All rights reserved This is the specification of Model FSP300-60GHT,(85)F; AC-line powered switching power supply with active PFC (Power Factor Correction) circuit, meet EN61000-3-2 and with Full Range Input features. Also, +5Vsb power is less than 0.5Winput at power off mode (PS_ON input at high state) which is comply with ErP Lot 6 year 2013 requirement.
PAGE 5
文件資料管制文件資料管制文件資料管制 All rights reserved 3.1. AC INPUT Parameter Min. Nom.(1) Max. Unit 90 115 132 Vin (115VAC) VAC rms 180 230 264 Vin (230VAC) VAC rms 47 -63 Vin Frequency HZ ◆ Nominal voltages for test purposes are considered to be within ±1.0V of nominal. 3.2.
PAGE 6
文件資料管制文件資料管制文件資料管制 All rights reserved 300W(loading shown in Amps) Loading +12V1 +12V2 +5V +3.3V -12V +5Vsb Full 8.64 9.88 8.49 7.72 0.31 1.23 Typical 4.32 4.94 4.24 3.86 0.15 0.62 Light 1.73 1.98 1.7 1.54 0.06 0.25 Table 2. Minimum Efficiency Vs Load Loading Voltage Full load Typical load Light load Required Minimum Efficiency 115V 82% 85% 82% Required Minimum Efficiency 230V 82% 85% 82% 3.4.2 Standby Power Consumption (+5Vsb): Input Power < 0.
PAGE 7
文件資料管制文件資料管制文件資料管制 All rights reserved The cross regulation defined as follows, the voltage regulation limits DC include DC Output ripple & noise. LOAD +3.3V +5V +12V1 +12V2 -12V +5VSB condition_1 X X X X X 2A condition_2 0.5A 0.2A 0.1A 0.5A 0.1A 0A condition_3 0.5A 15A 2A 2A 0.05A 0.05A condition_4 0.5A 2A 14A 1A 0A 0A condition_5 0.5A 2A 1A 16A 0A 0A condition_6 16A 3A 1A 1A 0A 0A condition_7 0.5A 21A 7.6A 7.6A 0.5A 1A condition_8 20A 9A 7.
PAGE 8
文件資料管制文件資料管制文件資料管制 All rights reserved +3.3V 3.76V - 4.8V +5V 5.6V - 7.0V +12V 13.0V - 16.5V 4.6. OVER CURRENT PROTECTION Output voltage +3.3V Max. over current limit 60A +5V +12V1 +12V2 48A 27A 27A 4.7. SHORT CIRCUIT PROTECTION Output short circuit is defined to be a short circuit load of less than 0.1 ohm. In the event of an output short circuit condition on +3.3V, +5V, +12V or–12V output, the power supply will shut down and latch off without damage to the power supply.
PAGE 9
文件資料管制文件資料管制文件資料管制 All rights reserved T4: Power-ok rise time: T4 < 10 ms T5: AC loss to PWR_OK hold-up time :T5 ≥16 ms T6: Power down warning :T6 ≥1 ms 4.9. The main power supply shall be off when the PS_ON pin is floating (open collector). The ON/STBY pin of P1 must remain off state for 5 Sec (maximum) prior to switching to the ON state. 5. FAN NOISE REQUIREMENTS 5.1. The subject power supply is cooled by a self-contained, 80mm×20mm, 12VDC fan. 6.
PAGE 10
文件資料管制文件資料管制文件資料管制 All rights reserved The power supply reliability when calculated by MIL-HDBK-217; latest revision, are exceed 100,000 hours with all output at 80% full load and an ambient temperature of 25℃. 6.6. DIELECTRIC STRENGTH Primary to Frame Ground : 1800 Vac for 1 sec. Primary to Secondary : 1800Vac for 1 sec 6.7. INSULATION RESISTANCE Primary to Frame Ground : 20 Meg.ohms Minimum Primary to Secondary : 20 Meg.ohms Minimum 7.