Data Sheet

ManualsBrandsFSP Fortron ManualsComputer & OfficeIndustrial PC PSU FSP Fortron FSP220-50FGBBI 220 W 80 PLUS Bronze

電氣規格書

ESD-00000467

Released Date:2019/03/13-08:33:25

FSP220-50FGBBI/50FGBBI(M)

Summary of content (10 pages)

PAGE 1
電氣規格書 ESD-00000467 FSP220-50FGBBI/50FGBBI(M) Released Date:2019/03/13-08:33:25
PAGE 2
文件資料管制文件資料管制文件資料管制 All rights reserved 台灣桃園市建國東路 22 號 NO.22,Jianguo E, Rd.,Taoyuan City,Taiwan,R.O.C. TEL:+886-3-375-9888 FAX:+886-3-375-6966 SPECIFICATION FSP220-50FGBBI FSP220-50FGBBI (M) 1/9禁止翻印外洩 All rights reserved Main Feature Active PFC Circuit Full Range Input MAY.24.2018 REV:1.3 ESD-00000467-R0B.
PAGE 3
文件資料管制文件資料管制文件資料管制 All rights reserved MODEL:FSP220-50FGBBI/ FSP220-50FGBBI(M) Revision History Rev Description Date Author 1.0 First Edition 2017/04/14 Sam 1.1 1.修改 OCP 保護點 2. cross regulation 修改 3. 4.1.2. LOAD CAPACITY SPECIFICATIONS 4. 5.1. TEMPERATURE RANGE 由 250W-> 220W 5. update EMI CISPR 22-> CISPR 32 2017/11/24 Sam 1.2 4.1.1. OUTPUT RATING CHANGE +12V MIN load form 0.5A to 0.05A 2018.4.9 Winnie 1.3 1. cross regulation 修改 Load2 +12V 4A->8A 2018.05.
PAGE 4
文件資料管制文件資料管制文件資料管制 All rights reserved 1. GENERAL DESCRIPTION AND SCOPE This is the specification of Model FSP220-50FGBBI/ FSP220-50FGBBI(M); AC-line powered switching power supply with active PFC (Power Factor Correction) circuit, meet EN61000-3-2 and with Full Range Input features. Designed and manufactured by FSP GROUP. The specification below is intended to describe as detailedly as possible the functions and performance of the subject power supply.
PAGE 5
文件資料管制文件資料管制文件資料管制 All rights reserved 4.1.1. OUTPUT RATING Output 1 2 3 4 5 Nominal +3.3V +5V +12V -12V +5VSB Regulation ±5% ±5% ±5% ±10% ±5% Ripple/Noise 50mV 50mV 120mV 120mV 50mV Min 0.0A 0.2A 0.05A 0.0 A 0.0 A Max 8.0 A 12.0 A 14.0 A 0.3A 2.5A ※ –12V,+3.3V, +5V,+12V will have the regulation to ±10% when all load take off. The +3.3V and +5V total output shall not exceed 61watts. The total output for this subject power supply is 220 watts.
PAGE 6
文件資料管制文件資料管制文件資料管制 All rights reserved 4.1.5.OVER VOLTAGE PROTECTION Voltage Source + 3.3 Vdc +5Vdc +12Vdc Protection Point 3.7V-4.5V 5.7V-6.5V 13.3V – 15.5V 4.1.6. OVER-CURRENT PROTECTION OUTPUT VOLTAGE +3.3V +5V +12V 4.1.7. OVER POWER OCP 10A-15A 15A-20A 16A-24A PROTECTION Total output shall not exceed 220 watts , in the event of an output total power condition on output , If the total exceed 150% , the power supply will shutdown and latch off without damage to the power supply. 4.1.8.
PAGE 7
文件資料管制文件資料管制文件資料管制 All rights reserved PS_ON ON OFF P.G. SENSE LEVEL 95% +5V O/P P.G. T1 < 20mS T2 = 100~500mS 4.2. OUTPUT TRANSIENT LOAD RESPONSE T3 > 1mS T1 T2 The output voltages shall remain within the limits specified T3 in 4.1.1 output rating table in page 4 for the step loading and within the limits specified in Table 1 for the capacitive loading. The load transient repetition rate shall be tested between 50Hz and 5 kHz at duty cycles ranging from 10%-90%.
PAGE 8
文件資料管制文件資料管制文件資料管制 All rights reserved 115V 230V 4.0 Amps – rms maximum 2.0 Amps – rms maximum 4.4. EFFICIENCY 115VAC 230VAC Full load (100%) 82% 82% Typical load (50%) 85% 85% Light load (20%) 82% 82% (loading shown in Amps) Loading Full (100%) Typical (50%) Light (20%) +12V 12.57 6.28 2.51 +5V 7.60 3.80 1.52 +3.3V 5.07 2.53 1.01 -12V 0.27 0.13 0.05 +5Vsb 2.24 1.12 0.45 4.5.
PAGE 9
文件資料管制文件資料管制文件資料管制 All rights reserved The power supply will be compliant with each item in this specification for the following Environmental conditions. 5.1. TEMPERATURE RANGE Operating Storage 0 to +50 deg. C FOR 220W -20 to +80 deg. C 5.2. HUMIDITY Operating Storage 85% RH, Non-condensing 95% RH, Non-condensing 5.3. VIBRATION The subject power supply will withstand the following imposed conditions without experiencing non-recoverable failure or deviation from specified output characteristics.
PAGE 10
文件資料管制文件資料管制文件資料管制 All rights reserved 6.1. LEAKAGE CURRENT The leakage current from AC to safety ground will not exceed 3.5 mA-rms at 264Vac, 50 Hz. 7. ELECTORMAGNETIC COMPATIBILITY 7.1 LINE CONDUCTED EMI The subject power supplies will meet FCC class B requirements . 7.2. RADIATED EMI The subject power supplies will meet FCC and CISPR 32 requirements . 8. LABELLING Label marking will be permanent, legible and complied with all agency requirements. 8.1.