SPECIFICATION ESD09081968 Released Date:2011/06/23-10:57:13
1/13禁止翻印外洩 文件資料管制 文件資料管制 文件資料管制 台灣 桃園市建國東路 22 號 NO.22,Jianguo E, Rd.,Taoyuan City,Taiwan,R.O.C. TEL:+886-3-375-9888 FAX:+886-3-375-6966 SPECIFICATION FSP220-60LE(STD001) 9PA2201157 Main Feature: Active PFC Circuit Full Range Input APR 8,2010 REV: 02 ESD09081968-R6.
文件資料管制 文件資料管制 文件資料管制 MODEL: FSP220-60LE Revision History Rev 02 2/13禁止翻印外洩 Description UPDATE Erp DESCRIPTION Date Author 4.8 KARL 2 ESD09081968-R6.
文件資料管制 文件資料管制 文件資料管制 1. GENERAL DESCRIPTION AND SCOPE This is the specification of Model FSP220-60LE; AC-line powered switching power supply with active PFC (Power Factor Correction) circuit, meet EN61000-3-2 and with Full Range Input features. Designed and manufactured by FSP GROUP. The 5Vsb power is less than 1Winput at power off mode (PS_ON input at high state) which is comply with EuP Lot 6 year 2010 requirement.
文件資料管制 文件資料管制 文件資料管制 3. PHYSICAL REQUIREMENTS 3.1 MECHANICAL SPECIFICATIONS The mechanical drawing of the subject power supply, which indicate the form factor, location of the mounting holes, location, the length of the connectors, and other physical specifications of the subject power supply. Please refer to the attachment drawing. 3.2 CONNECTOR SPECIFICATIONS The power supply connectors are: AC Inlet : Standard inlet socket 10A/250V, UL/CSA/VDE approved.
文件資料管制 文件資料管制 文件資料管制 4. ELECTRICAL REQUIREMENTS 4.1 OUTPUT ELECTRICAL REQUIREMENTS The subject power supply will meet all electrical specifications below, over the full operation temperature range and dynamic load regulation. 4.1.1. OUTPUT RATING Output 1 2 3 4 5 6 Nominal +3.3V +5V +12V1 +12V2 -12V +5VSB Regulation ±5% ±5% ±5% ±5% ±10% ±5% Ripple/Noise 50mV 50mV 120mV 120mV 120mV 50mV Min 0.5A 0.5A 1.0A 1.0A 0A 0A Max 14.0 A 16.0 A 16.0 A 10.0A 0.8 A 2.5A peak (1) 220W(50℃) : +3.
文件資料管制 文件資料管制 文件資料管制 250W Load condition No. +3.3V +5V +12V1 +12V2 -12V +5Vsb FL1 14.0 12.76 5.0 5.2 0.4 2.5 FL2 9.0 16.0 5.0 5.2 0.5 2.5 FL3 1.0 2.0 14.0 4.2 0.5 2.5 FL4 1.0 2.0 8.2 10.0 0.5 2.5 CR1 0.5 16.0 3.5 3.5 0.1 2.5 CR2 1.0 2.0 5.5 10.0 0.5 0 CR3 14.0 0.5 1.0 1.0 0.1 0 CR4 0.5 2.0 16.0 1.0 0.1 0 ML 0.5 1.5 1.0 1.0 0.1 0 --- A 4.1.3. HOLD-UP TIME (@FULL LOAD) 220W: 115V / 60Hz : 17 mSec. Minimum. 230V / 50Hz : 17 mSec. Minimum.
文件資料管制 文件資料管制 文件資料管制 4.1.6.SHORT CIRCUIT PROTECTION Output short circuit is defined to be a short circuit load of less than 0.1 ohm. In the event of an output short circuit condition on +3.3V, +5V or +12V output, the power supply will shutdown and latch off without damage to the power supply. The power supply shall return to normal operation after the short circuit has been removed and the power switch has been turned off for no more than 2 seconds.
文件資料管制 文件資料管制 文件資料管制 PS_ON ON OFF P.G. SENSE LEVEL 95% Main O/P P.G. T1 T1 < 20mS T2 = 100~500mS T3 > 1mS T2 T3 4.2. OUTPUT TRANSIENT LOAD RESPONSE +5V and +12V must be within specification for a step change in current as specified below. The outputs will be tested one section at a time with all other sections at maximum load. The test transition will be from IA to IB and IB to IA. The step current will have a nominal transition time of 0.5 amp per microsecond for +5V and 0.
文件資料管制 文件資料管制 文件資料管制 +3.3Vdc: IA: 14.0 amps IB: Volts variation: Setting time: 10.0 amps 400 mV max (p-p) 10 ms max IA IB 10ms 10ms 4.3. INPUT ELECTRICAL SPECIFICATIONS 4.3.1. VOLTAGE RANGE PARAMETER V-in Range UNITS V-rms 90 - 264 4.3.2. INPUT FREQUENCY INPUT FREQUENCY 47–63Hz 4.3.3. INRUSH CURRENT (Cold start – 25 deg. C) 115V 230V No damage No damage (No damage) 4.3.4. INPUT LINE CURRENT 9/13禁止翻印外洩 115V 230V 5.0 Amps – rms maximum 3.0 Amps – rms maximum 9 ESD09081968-R6.
文件資料管制 文件資料管制 文件資料管制 4.4. EFFICIENCY Full load (100%) 80% 80% 115VAC 230VAC Full Typical Light 220W(Loading shown in Amps) +5V +3.3V 6.91 6.05 3.45 3.02 1.38 1.21 -12V 0.4 0.2 0.08 +5Vsb 1.24 0.62 0.25 +12V2 4.8 2.4 1.0 250W(Loading shown in Amps) +5V +3.3V 10.1 8.9 5.1 4.4 2.0 1.8 -12V 0.8 0.1 0.1 +5Vsb 2.4 1.0 0.5 Loading Full Typical Light +12V1 7.6 3.8 1.5 Light load (20%) 80% 80% +12V2 4.95 2.48 0.99 Loading +12V1 7.93 3.96 1.59 Typical load (50%) 80% 80% 4.5.
文件資料管制 文件資料管制 文件資料管制 5. ENVIRONMENTAL REQUIREMENTS The power supply will be compliant with each item in this specification for the following Environmental conditions. 5.1. TEMPERATURE RANGE Operating Operating 250W 220W Storage 0 to +25 deg. C 0 to +50 deg. C -20 to +80 deg. C Operating Storage 85% RH, Non-condensing 95% RH, Non-condensing 5.2. HUMIDITY 5.3.
文件資料管制 文件資料管制 文件資料管制 The leakage current from AC to safety ground will not exceed 3.5 mA-rms at 264Vac, 50 Hz. 7. ELECTORMAGNETIC COMPATIBILITY 7.1 LINE CONDUCTED EMI The subject power supply will meet FCC and VFG class B requirements under full load conditions. 7.2. RADIATED EMI The subject power suppy will meet FCC and CISPR 22 requirements under normal load conditions. 8. LABELLING Label marking will be permanent, legible and complied with all agency requirements. 8.1.
13/13禁止翻印外洩 文件資料管制 文件資料管制 文件資料管制 13 ESD09081968-R6.