Instruction Manual REACH-IN REFRIGERATORS M-RRF-1D, M-RRF-2D REACH-IN FREEZERS M-RRF-1D, M-RRF-2D MRFZ-1D, MRFZ-2D, MRFZ-3D This manual contains important information regarding your FSE by Culitek unit. Please read this manual thoroughly prior to equipment set-up, operation and maintenance. Failure to comply with regular maintenance guidelines outlined in this manual may void the warranty.
Reach-Ins MANUAL WARNING DANGER – RISK OF FIRE OR EXPLOSION. FLAMMABLE REFRIGERANT USED. TO BE REPAIRED ONLY BY TRAINED SERVICE PERSONNEL. DO NOT PUNCTURE REFRIGERANT TUBING. PELIGRO - RIESGO DE INCENDIO O EXPLOSION. REFRIGERANTE INFLAMABLE UTILIZADO. PARASER REPARADO SOLAMENTE POR PERSONAL DE SERVICIO CALIFICADO. NO PINCHAR LA TUBERÍA REFRIGERANTE. DANGER – RISQUE DE FEU OU D’EXPLOSION. LE FRIGORIGÈNE EST INFLAMMABLE. CONFIER LESRÉPARATIONS À UN TECHNICIEN SPÉCIALISÉ.
Reach-Ins MANUAL WARNINGS • To minimize shock and fire hazards, be sure not to over load the outlet. One outlet should be designated to the unit only. • Do not use extension cords. • Do not put hands under the unit when moving. • When the unit is not being used for an extended period of time, unplug the unit from the outlet. • After unplugging the unit, wait at least 10 minutes before re-plugging it. Failure to wait the allotted time may cause damage to the compressor.
Reach-Ins MANUAL TEMPERATURE CONTROLS The temperature controls are factory set to maintain an average temperature of 38°F. FREEZER CONTROL REFRIGERATOR CONTROL mute set Regulating the Temperature Your new refrigerator or freezer is now manufactured to run at ideal temperatures for food quality and should not require any alterations. Refrigerators are set to cycle between a base temperature of 33° Fahrenheit and a temperature maximum of 41° Fahrenheit.
Reach-Ins MANUAL REGULAR MAINTENANCE WARNING: Disconnect power cord before cleaning any parts of the unit. CLEANING THE CONDENSER COIL For efficient operation, it is important that the condenser surface be kept free of dust, dirt, and lint. It is highly recommended that the condenser coil be cleaned at least once a month. Clean with a commercial condenser coil cleaner and brush the condenser fins from top to bottom. After cleaning, straighten any bent fins with a fine comb.
Reach-Ins MANUAL TROUBLESHOOTING Before requesting any service on the unit, please check the following chart. Service calls resulting from lack of maintenance or misuse is not covered under the warranty and may also void the warranty. Please note that this guide serves only as a reference for solutions to common problems.
Reach-In MANUAL SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION Cabinet temperature is too warm Thermostat set too warm Set thermostat to lower temperature Blocked air flow Re-arrange products to allow proper air flow.
Refrigeration WARRANTY March 2021 TWO YEAR WARRANTY FSE by Culitek warrants to the original purchaser of this unit, the cabinet and all parts thereof, to be free from defects in material or workmanship, under normal use and service, for a period of two (2) years from the date of original purchase. Any parts covered by this warranty that are examined and determined to have been defective within two (2) years of original purchase shall be repaired or replaced as stated below.
