Use and Care Manual

6
H. AftermakingsurethatO-ringandwavespringinside
topofbowlareinplace,reassemblebowltohead.
NOTE:MakecertainO-ringisgenerouslylubricated
NOTE:Wavespringendsshouldbepointeddowntopre-
ventthewavespringfrominterferingwithreassembly.
I. Reconnectdraintubetobulkheadttingbypushing
tubeintottinguntilitlocksinposition.
J. Reinstallsideandtoppanels.
K. Repressurizedryerandresumeoperation.
Element o-ring
Separator Element
Bowl o-ring
Drain Mechanism
Wave Spring
Tube
Hose
Barb
3.4 Automatic condensate drain
• Checkdailytobesureautomaticdrainisdischarg-
ing.
• Replacedrainmechanismyearly.
A. Shut-offcompressedairsupplytothedryerandde-
pressurize.
B. Removetoppanel.
C. Removetwoscrewsholdingsidepanelthenremove
side panel by sliding upwards.
D. Disconnectdraintubefrombulkheadttingin
cabinetbase.Toremove,presstheplasticcollarin,
towardthetting,whilepullingthetubeoutofthe
tting.
E. Removebowl-pushbowlup,turn1/8thturntoyour
left,andpullbowlstraightdown.
F. Removedraintubettingfrombottomofbowl.
G. Removeolddrainmechanismbyturningknurled
ttingtotheright(clockwise)andremove.
H. Installnewdrainmechanism.Ifnecessary,usea
wire or pencil to guide the new mechanism into
place.
I. Reassembledraintubettingtobowl.
J. AftermakingsurethatlargeO-ringinlterheadis
inplace,reassemblebowltohead.
K. Reconnectdraintubetobulkheadttingbypush-
ingtubeintottinguntilitlocksinposition.
L. Reinstalltopandsidepanels.
M. Repressurizedryerandresumeoperation.