Use and Care Manual

5
3.0 MAINTENANCE
 DRYERISAPRESSURECONTAININGDEVICE.
DEPRESSURIZEBEFORESERVICING.
3.1 Ambient air filter - Clean accumulated dust and
dirt from ambient air filter monthly or more of-
ten if air flow across the condenser is impeded.
A. Removetoppanel.
B. Removeambientairlterbyslidingupwards.
C. Washwithsoapandwaterandallowtodrybeforere-
installing.
NOTE:Donotusesolventstocleanambientairlter.
D. Reinstalllterandtoppanel.
3.2 Inlet strainer - clean inlet strainer monthly or
more often if rapid clogging occurs.
A. Shut-offcompressedairsupplytothestrainerand
depressurize.
B. Removescreenandcleanorreplace.
C. Reinstall.
Screen
3.3 Replace separator/filter element yearly or
more often if pressure drop across the dryer is
excessive.
A. Shut-offcompressedairsupplytothedryerandde-
pressurize.
B. Removetoppanel.
C. Removetwoscrewsholdingsidepanelandremove
side panel by sliding upwards.
D. Disconnectdraintubefrombulkheadttingin
cabinetbase.Toremove,presstheplasticcollarin,
towardthetting,whilepullingthetubeoutofthe
tting.
E. Removebowl-pushbowlup,turnbowl1/8thturnto
yourleft,andpullstraightdown.
F. Cleanlterbowl.  
G. Replaceelement.
1. Replacingcompleteelement
 a) Pulloffoldelementanddiscard.
 b) MakecertainO-ringinsidetopofreplacement
elementisinplaceandpushelementontolter
head.
2. Replacingsleeveonly
 a) Pullelementstraightdowntoremove.
b) Removeboltandbottomcapandremovedispos-
ableltersleeve.
c) Cleanseparatorcorewithsoapandwaterifnec-
essary
d) Slidenewltersleeveoverseparatorcoreand
replace bottom cap and hand tighten bolt.
e) MakecertainO-ringinsidetopofelementisin
placeandpushelementontolterhead.