MSDS
FSC-8000 COMPRESSOR FLUID Page Number: 2
Mixture of severely hydrotreated and hydrocracked base oil (petroleum).
Mixture
-
Composition/information on ingredients
Name CAS number %
3 .
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting in
this section.
The base oil may be a mixture of the following CAS#s: 8042-47-5, 64742-46-7, 64742-47-8, 64742-53-6, 64742-54-7,
64742-55-8, 72623-84-8, 72623-85-9, 72623-86-0, 72623-87-1, 178603-64-0, 178603-65-1, 178603-66-2, 445411-73-4
Wash out mouth with water. Do not induce vomiting unless directed to do so by medical
personnel. Never give anything by mouth to an unconscious person. Get medical
attention immediately.
Check for and remove any contact lenses. Immediately flush eyes with plenty of water
for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical
attention immediately.
In case of contact, immediately flush skin with plenty of water for at least 15 minutes
while removing contaminated clothing and shoes. Wash skin thoroughly with soap and
water or use recognized skin cleanser. Wash clothing before reuse. Clean shoes
thoroughly before reuse. Get medical attention immediately.
Move exposed person to fresh air. If not breathing, if breathing is irregular or if
respiratory arrest occurs, provide artificial respiration or oxygen by trained personnel.
Loosen tight clothing such as a collar, tie, belt or waistband. Get medical attention
immediately.
First aid measures
Eye contact
Skin contact
Inhalation
Ingestion
No specific treatment. Treat symptomatically. Contact poison treatment specialist
immediately if large quantities have been ingested or inhaled.
Notes to physician
:
:
:
:
:
4 .
Protection of first-aiders :
No action shall be taken involving any personal risk or without suitable training. It may
be dangerous to the person providing aid to give mouth-to-mouth resuscitation.
Use an extinguishing agent suitable for the surrounding fire.
Low fire hazard. This material must be heated before ignition will occur.
Do not pressurize, cut, weld, braze, solder, drill, grind or expose containers to heat or
sources of ignition.
Fire-fighting measures
Extinguishing media
Special remarks on fire
hazards
Special remarks on
explosion hazards
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training.
May be combustible at high temperature.
Special protective
equipment for fire-fighters
Fire-fighters should wear appropriate protective equipment and self-contained breathing
apparatus (SCBA) with a full face-piece operated in positive pressure mode.
:
:
:
5 .
Special exposure hazards :
None known.
Suitable :
Not suitable :
Products of combustion :
Carbon oxides (CO, CO2), smoke and irritating vapours as products of incomplete
combustion.
Flammability of the product :
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. Do not touch or walk through spilled material. Avoid breathing vapor or mist.
Provide adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Put on appropriate personal protective equipment (see Section 8).
Accidental release measures
Personal precautions :
6 .
Date of issue : 9/20/2012.
Page: 2/7