iCommand-Touch Manual

CAP-837
2.8 Messages
2.8.1
Overview
Fig. 59: "State" screen
2.8.2
Warning
Warning message
Remarks
W021:
Final temperature high
The maximum permissible compressor final temper
ture (warning limit) has been exceeded (refer to the
"Factory settings" menu).
W022: Line pressure
high
The pressure has exceeded the limi
ble pressure
W023:
Temperature too low
The minimum temperature required to start has been
undercut (refer to the "Factory settings" menu).
W024:
Low. press. threshold
Minimum pressure has been undercut. Only relevant
for LLC slave operation (see "Contro
W025:
Check oil level/heat.
Heating limitation warning: The "Fault overpressure"
input was triggered during active heating (Delay 0.5
s).
W026: Adjustment wrong
At least one analogue input calibration value is inco
rect.
iCommand
51
Overview
A flashing warning triangle (Warning/Maintenance) or
(Fault) (Fig. 59
/1) will appear in the left top of the basic display, if a
new message is present. In addition a message pop
the bottom of the display the message in plain text (Fig.
message window can be closed with the quit button (Fig.
The fault icon in the title psi
flashes but only continues to flash until
the cause of the error has been corrected. By pressing on the warning
or fault icon in the title psi
, the plain text message can be opened
again.
Warning
A flashing warning triangle or a tool symbol will appear in the left top
of the basic display, if a warning is present. In addition a message
pop-
up appears at the bottom of the display the message in plain text.
The message window can be closed with the q
uit button. The warning
triangle stays in the title psi
until the cause of the message has been
remedied. The message is displayed again after a tap on the warning
triangle. The compressor continuous to run.
Remarks
The maximum permissible compressor final temper
a-
ture (warning limit) has been exceeded (refer to the
"Factory settings" menu).
The pressure has exceeded the limi
t (max. permissi-
ble pressure
– 7 psi).
The minimum temperature required to start has been
undercut (refer to the "Factory settings" menu).
Minimum pressure has been undercut. Only relevant
for LLC slave operation (see "Contro
l" menu).
Heating limitation warning: The "Fault overpressure"
input was triggered during active heating (Delay 0.5
At least one analogue input calibration value is inco
r-
iCommand – Touch
iCommand
- Touch
A flashing warning triangle (Warning/Maintenance) or
a tool symbol
/1) will appear in the left top of the basic display, if a
new message is present. In addition a message pop
-up appears at
the bottom of the display the message in plain text (Fig.
59/2). The
message window can be closed with the quit button (Fig.
59/3).
flashes but only continues to flash until
the cause of the error has been corrected. By pressing on the warning
, the plain text message can be opened
A flashing warning triangle or a tool symbol will appear in the left top
of the basic display, if a warning is present. In addition a message
up appears at the bottom of the display the message in plain text.
uit button. The warning
until the cause of the message has been
remedied. The message is displayed again after a tap on the warning
Compressor type
All
All
All
All
All
All