iCommand-Touch Manual

CAP-837
2.7.9.1 "LLC priorities" screen
Fig. 53: "LLC priorities" screen
This menu contains the settings for the priority assignments of the
individual compressors. The values set here only apply if no timer
channel of the timer LLC priorities is active.
Parameter
Value setting/Initial setting/Remarks
Priority compres-
sor 1 – 5
Specifies a priority level for each compressor in the
LLC series. Compressors with high priority ware
preferred when switching on. Lead lag control only
takes place between compressors of the same prior
ty.
Setting range: OFF (compressor is never switched
on) / Low / Normal / High
Initial setting: Normal
2.7.9.2
"Switching times LLC" screen
Fig. 54: "Switching times LLC" screen
The switch
applies for the LLC master. Programming is done analogous to the
"Switching times compr." in section
times compr." screen
iCommand
48
This menu contains the settings for the priority assignments of the
individual compressors. The values set here only apply if no timer
channel of the timer LLC priorities is active.
Value setting/Initial setting/Remarks
Compressor
type
Specifies a priority level for each compressor in the
LLC series. Compressors with high priority ware
preferred when switching on. Lead lag control only
takes place between compressors of the same prior
i-
Setting range: OFF (compressor is never switched
on) / Low / Normal / High
Initial setting: Normal
All
"Switching times LLC" screen
The switch
-
on/off times of the LLC are defined in this menu. This only
applies for the LLC master. Programming is done analogous to the
"Switching times compr." in section
 Chapter 2.7.4.2 ‘
"Switching
times compr." screen
’ on page 36.
iCommand – Touch
iCommand
- Touch
This menu contains the settings for the priority assignments of the
individual compressors. The values set here only apply if no timer
Compressor
State
Editable
on/off times of the LLC are defined in this menu. This only
applies for the LLC master. Programming is done analogous to the
"Switching